Time-resolved chemiluminescence technique for the microdetermination of proteins based on their complexation with copper(II).

Based on the complexation between proteins and Cu(II) coupled with the time-resolved chemiluminescence (CL) technique, a highly sensitive and quantitative assay for measuring proteins in solution is described. The complexes of proteins with Cu(II) have a strongly catalytic effect on the luminol-H2O2 CL reaction. Because the CL emission produced by the complexes is much more long-lived than that by Cu(II), the CL signals originating from proteins can be easily identified and measured with a time-resolved technique. On this basis, bovine albumin fraction V (BAF V) can be quantitatively determined in the range of 0.01 - 5.0 microg/ml with a detection limit of 5.8 ng/ml. The results show that the proposed assay exhibits a small variation in the response values for the same amount of different proteins, as compared to the Lowry as well as Bradford assays. The CL assay has also been studied for the detection of immobilized proteins.     

Colorimetric recognition of different enzymology-concerning transition metals based on a hybrid cluster complex.

A hybrid cluster complex, formed by chelating a chromogenic ligand to a [2Fe-2S] cluster, sensitively exhibited differential colorimetric responses towards Hg2+, Cd2+, Cr3+, Pb2, Sn2+, Cu2+, Zn2+, Fe3+ and Co2+ in water at physiological pH. Speciation of some of these metal elements, such as Cr(III) and Sn(IV), was also studied by UV/Vis absorption.     

Estimation of kinetics parameters for the adsorption of human serum albumin onto hydroxyapatite-modified silver electrodes by piezoelectric quartz crystal impedance analysis.

The adsorption of human serum albumin onto hydroxyapatite-modified silver electrodes has been in situ investigated by utilizing the piezoelectric quartz crystal impedance technique. The changes of equivalent circuit parameters were used to interpret the adsorption process. A kinetic model of two consecutive steps was derived to describe the process and compared with a first-order kinetic model by using residual analysis. The experimental data of frequency shift fitted to the model and kinetics parameters, k1, k2, psi1, psi2 and qr, were obtained. All fitted results were in reasonable agreement with the corresponding experimental results. Two adsorption constants (7.19 kJ mol(-1) and 22.89 kJ mol(-1)) were calculated according to the Arrhenius formula.     

反射式微光机电系统(MOEMS)的研究现状与展望

反射式微光机电系统是微光机电系统中的重要组成部分,近年来得到了较快的发展。介绍了反射式微光机电系统(MOEMS)的研究现状和最新进展。根据反射式微光机电系统的分类,列举了一些具有代表性的反射式MOEMS器件。简要介绍了反射式MOEMS的加工工艺;阐述了反射式MOEMS的应用领域;展望了发展前景。     

密封容器中后处理制备Tl2Ba2CaCu2Oy高温超导薄膜及其性能研究

以铝酸镧（001）单晶为基片，采用两步法制备Tl2Ba2CaCu2Oy（Tl 2212）高 温超导薄膜.首先，利用脉冲激光沉积（PLD）工艺沉积Ba2CaCu2Ox非晶前驱体薄膜；然后，前驱体薄膜在高温（720—850℃）下密封钢容器里铊化结晶形成Tl 2212薄膜.XRD结果表明Tl2212 薄膜是沿c轴方向生长的，其相组成为Tl 2212，摇摆曲线（0012）的半高宽为0.72° ，SEM图像显示其表面光滑平整，其零电阻温度为106.2K. 关键词： Tl 2212超导薄膜 脉冲激光沉积     

基于Apollo信号控制台的NQR炸药探测方法

介绍了一种基于Apollo信号控制台的核四极矩共振（NQR）炸药探测方法，描述了系统的结构组成、工作原理和实现方法，并给出了对RDX的测试试验结果. 试验表明该方法可实现对RDX信号的探测.     

薄膜外延生长的计算机模拟

以Cu膜为例，用Monte-Carlo算法模拟了薄膜生长的随机过程，并提出了更加完善的模型.在合理选择原子间相互作用计算方法的基础上，考虑了原子的吸附、在生长表面的迁移及迁移所引起的近邻原子连带效应、从生长表面的脱附等过程.模拟计算了薄膜的早期成核情况以及表面粗糙度和相对密度.结果表明，随着衬底温度的升高或入射率的降低，沉积在衬底上的原子逐步由离散型分布向聚集状态过渡形成一些岛核，并且逐步由二维岛核向三维岛核过渡.在一定的原子入射率下，存在三个优化温度，成核率最高时的最大成核温度Tn、薄膜的表面粗糙度最低 关键词： Monte-Carlo算法 计算机模拟 薄膜生长     

微波谐振腔Q值对磁激子振幅不稳定态阈值的影响

基于Safonov和Yamazaki所发展的激励自旋波非线性辐射衰减的理论［J. MMM. 161 (1996 ) 275］, 考虑磁激子与磁激子以及磁激子与光子的两种非线性相互作用过程，计算了微波谐振腔Q值对磁激子振幅不稳定态阈值的影响，结果与实验数据基本一致. 关键词： 磁激子 谐振器 铁磁体     

掺氢与激励电路对钡蒸气激光输出特性的影响

对用Blumlein电路放电激励的钡蒸气激光在掺氢和不掺氢时的输出特性进行了实验研究.结果表明，用掺氢1.5%的氖气作缓冲气体能使激光功率增加近2倍.在此基础上，进一步比较了相互作用电路与Blumlein电路时钡蒸气激光的输出特性，发现相互作用电路能显著提高钡蒸气激光的输出功率和效率，获得了3W最大功率和0.4%效率的1.5μm波长激光输出.测量并分析了各工作参量与激光功率之间的关系，定性解释了掺氢与相互作用电路的作用机理 . 关键词： Blumlein电路 相互作用电路 掺氢 钡蒸气激光     

聚乙烯基咔唑与Alq3混合薄膜的发光性能与能量传递过程

研究了Alq3与聚乙烯基咔唑(PVK)按不同比例的混合体系制备的薄膜的发光特性.通过对混合薄膜的吸收光谱、激发光谱和发射光谱的分析，研究了PVK与Alq3之间的 能量传递规律.当Alq3与PVK的质量比为1∶7时，能量传递效率最高.用一个由单链模 型扩展到包括杂质的哈密顿量对实验进行模拟，发现该模型能够较好地解释有关的实验结果. 关键词： 吸收光谱 激发光谱 发射光谱 能量传递